In the previous NTC Measurements article, was shown the basic approaches and few variations of them in order to use an NTC, by following the suggestions provided in the datasheet and taking the correct assumptions in all the temperature signal processing. These suggestions are usually not provided, because with a bit of math a lot … Continue reading NTC Measurements (part 2/2)
Once upon a time, during a lecture about electronics, more specifically on crystal quartz oscillators, a professor said that you can break a crystal oscillator by dropping it, because the quartz inside can be broken due to the fall, even if it seems solid like a common 1/4W resistor. Let me start with a briefing … Continue reading Smoked crystals (Oscillator)
When dealing with low-cost, home made termometers, the choice often fall on the NTCs. These sensors are resistors which are varying their resistance in function of the temperature, with a negative trend: Negative Temperature Coefficient is their name, also known as Thermistor. That means higher the temperature, lower the resistance: We observe that this cheap … Continue reading NTC Measurements (Part 1/2)
ALEA 